GE - General Electric JKP64GP Legacy

User Manual - Page 37

For JKP64GP.

PDF File Manual, 44 pages, Download pdf file

Loading ...
Loading ...
Loading ...
~roiler Pan and Rack
Lower Oven
After broiling,
remove the broiler pan from the
oven. Remove the rack from the pan. Carefully pour
out
grease
from the
pan
into a proper container. Wash
and rinse the broiler pan and rack in hot
water with a
soap-filled or plastic scouring pad.
If food has burned on, sprinkle
the
rack with
detergent
while hot and cover with
wet
paper
towels or a dishcloth. Soaking the pan will remove
burned-on
foods.
The broiler pan may
be
cleaned with a commercial
oven cleaner. Do not use
an
oven cleaner on the rack.
Both the broiler pan and rack can also be cleaned in
the dishwasher.
Do not store a soiled broiler pan and rack anywhere in
the cooking center.
Do not clean the broiler pan or rack in the
self-cleaning oven.
Light Replacement
Lower
Oven
CAUTION: Before replacing your oven light bulb,
disconnect the electric power for your oven at the
main fuse or circuit breaker panel.
Be sure to
let
the light cover and bulb cool completely
before removing or replacing them. When in use, light
bulbs can become warm
enough
to break if touched
with a moist cloth or towel. When cleaning, avoid
~.}uching
warm
lights
with cleaning cloths if the light
/er
is removed.
The oven light (bulb) is covered with a glass removable
cover which is held in place with a wire. Remove the
oven door, if desired, to reach the cover easily.
To remove:
Hold
your hand under the
‘/
cover so it doesn’t fall
when released. With
fingers of the same hand,
@Q
@
,:,,p@
)
~~
firmly push back the wire
G
until it clears the cover.
I “
i
Lift off the cover.
DO NOT REMOVE ANY SCREWS.
Replace bulb with 40-watt home appliance bulb.
To replace cover:
Place it into the groove of the light receptacle. Pull
the wire forward to the center of cover until it snaps
in place. When in place, the wire holds the cover
firmly. Be certain the wire is in the depression in the
center of the cover.
Connect electric power to the oven.
Glass Surfaces
Painted Surfaces
To clean the outside glass finish, use a
glass
cleaner.
Painted surfaces include the control panel. Clean
Rinse and polish with a dry
cloth.
Do not allow the
these areas with soap and water or a vinegar and
water or cleaner to run down inside openings in the
water solution.
Do not use commercial oven
top of the oven door while cleaning.
cleaners, cleansing powders, steel wool or harsh
abrasives on any painted surface.
Oven Vent Duct
The oven is vented through a duct that’s located on the left side of the oven
just above the door. Moisture and vapors from the oven are vented through
L*
when
oven
is i
n
use,
Never cover the hole in the duct. TO do so Prevents it
in
functioning properly during cooking and cleaning.
(contittued next page)
Loading ...
Loading ...
Loading ...