Loading ...
Loading ...
Loading ...
Problem solving guide
93
Unsatisfactory drying results
Problem Cause and remedy
The laundry is too damp
after drying and
Check load appears in the
display.
The load is too small. The electronics could not as-
sess the residual moisture correctly.
Start the programme again and instead of a drying
level select a Timed drying programme.
In the future use a Timed drying programme for
small amounts of laundry.
During the spin cycle, the laundry formed a ring in
the drum because the laundry was distributed un-
evenly.
The laundry formed a ring during the thermospin be-
cause it was too damp or because the spin speed
was set too high.
Open the door and loosen the laundry.
Start the drying programme again with a lower
spin speed, or select Timed drying instead of a
drying level.
The laundry feels damp
after drying.
The Pre-ironing Extra was selected.
Unload the laundry and place it on hangers to fin-
ish drying.
Warm laundry can feel damp.
Spread the laundry out to cool it down.
The laundry is too damp
or too dry after a drying
cycle.
The desired residual moisture level is between two
drying stages.
Change the level of drying as described in “Set-
tings”, “Drying levels”.
There is still water in
the drum after drying.
There is a blockage in the water outlet.
Clean the drain filters and the drain pumps as de-
scribed in “Opening the door in the event of a
blocked drain outlet and/or power failure” and
check the height of the drainage point.
Loading ...
Loading ...
Loading ...