Loading ...
Loading ...
Loading ...
Settings
121
Installation requirements
Low water pressure
If the water pressure is too low, the
washer-dryer will stop the programme
and a water inlet fault message will
appear.
This setting can be activated to ensure
problem-free water intake where the
water pressure is constantly low.
Factory default setting: Low water pres-
sure is switched on.
Suds cooling
Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a Cot-
tons programme with a temperature of
70°C or higher is selected.
Activate suds cooling:
- To prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or slops basin
- In buildings where the drainage pipes
do not comply with DIN1986
Factory default setting: suds cooling is
switched off.
Temperature reduction
At high altitudes, water has a lower
boiling point. Miele recommends ac-
tivating the reduced temperature set-
ting at altitudes of 2000m or above to
prevent water from boiling. The max-
imum temperature is reduced to 80°C
even if a higher temperature is selec-
ted.
Factory default setting: the reduce tem-
perature setting is switched off.
Loading ...
Loading ...
Loading ...