Loading ...
Loading ...
Loading ...
EN
28
Assembly
www.bora.com
Connect the exhaust air duct [7] installed on-site to the
exhaust air arc [6].
Seal the duct connection so that it is airtight using
adhesive sealing tape UDB1.
Fasten the cooktop using the mounting brackets [8] at
the worktop.
Afterwards, insert the stainless steel grease filter [4]
and air inlet nozzle [3].
Seal the surrounding gap with a black heat-resistant
silicone sealing compound.
6.8 Establishing the power
connection
Observe all safety and warning information (see Safety
chapter).
Observe all national and regional laws and regulations
as well as the supplementary regulations of the local
utility companies.
INFO The power connection must only be
implemented by a certified engineer. He/she
also assumes responsibility for the proper
installation and commissioning.
INFO Connection via plug-in contacts, e.g. plugs with
earthing contacts, are not allowed.
INFO The device complies with IEC 61000-3-12
Switch off the main switch/automatic circuit breaker
before connecting the cooktop.
Protect the main switch/automatic circuit breaker
from being switched on without permission.
Make sure the device is not energised.
Only connect the cooktop using a permanent
connection to a type H 05 VV-F power supply line
with appropriate minimum cross section (s. Tab. Fuse
protection and minimum cross section).
Connection Fuse protection Minimum
cross-section
Three-phase-connection 3 x 16 A 2.5 mm
2
Two-phase-connection 2 x 16 A 2.5 mm
2
One-phase-connection 1 x 32 A 4 mm
2
Tab. 6.2 Fuse protection and minimum cross section
For surface installation
Make sure that the sealing tape is resting on the
worktop.
For flush installation
Make sure that the sealing tape of the cooktop is
sealed well all the way round.
1
2
Fig. 6.34 Height adjustment plates
[1] Cooktop
[2] Height adjustment plates
If necessary insert height adjustment plates [2].
54321
8
5
7
6
1
Fig. 6.35 Connecting the exhaust air duct + secure
[1] Cooktop
[2] Suction opening
[3] Air inlet nozzle
[4] Stainless steel grease filter
[5] Worktop cut-out
[6] Exhaust air arc
[7] Exhaust air duct
[8] Mounting bracket
Loading ...
Loading ...
Loading ...