Loading ...
Loading ...
Loading ...
EN
10
Safety
www.bora.com
2.3 Safety instructions – installation
The device must only be installed and
assembled by trained specialists who are
familiar with and comply with the standard
national regulations and supplementary
regulations of the local utility companies.
Work on electrical components must be
conducted by trained electrical personnel.
The electrical safety of the appliance is only
guaranteed if it is connected to a protective
conductor system that has been installed in
line with regulations. Ensure that this basic
safety precaution is met.
Cooktop
DANGER!
Risk of electric shock!
Incorrect connection of the device
to the mains voltage could cause
electric shocks.
Make sure that the device is firmly
connected to the mains voltage.
Make sure the device is connected
to a properly installed earth
conductor system.
Make sure a system is installed
which allows disconnection from
the network with a contact
opening width of at least 3 mm
across all poles (circuit breaker,
fuses, automatic circuit breakers,
contactors).
DANGER!
Risk of electric shock!
If the mains connection cable comes
into contact with hot hobs, it could
get damaged. A damaged mains
connection cable can cause a
(deadly) electric shock.
Make sure that the mains
connection cable cannot come
into contact with hot hobs.
Make sure that the connection
cable is not squashed or damaged.
CAUTION!
Lifting heavy loads can cause back
injuries!
If not correctly handled, removing
and installing the device can causes
injuries to the limbs or torso.
Removing the cooktop from the
packaging is a two-person job.
Placing the cooktop into the
worktop cut-out is a two-person
job.
Use appropriate aids to prevent
damage or injuries to limbs or
torso.
Cooktop extractor
DANGER!
Risk of poisoning from combustion
gases!
If the cooktop extractor is used in
exhaust mode, it draws in air from
the room in which it is installed as
well as from neighbouring rooms. If
there is insucient air supply, low
pressure will occur. Toxic gases
could be drawn out of the replace
that depends on the air in the room
or extraction ducting and back into
the room.
Make sure that there is always a
sufficient air supply.
Only use approved and tested
switchgear (e.g. window contact
switch, low-pressure monitor)
and have them approved by
authorised specialists (certified
chimney-sweep).
DANGER!
Risk of electric shock!
Incorrect stripping of the connection
cable to external switching devices
results in a risk of electric shock.
Ensure that the stated stripping
lengths are adhered to.
Loading ...
Loading ...
Loading ...