Loading ...
Loading ...
Loading ...
Installation Instructions
[] INSTALLING THE ANTI-TIP DEVICE
-4,WARNING!
• Range must be secured with an approved Anti-Tip
device.
• Unless properlg installed, the range could be tipped
bg gou or a child standing, sitting or leaning on an
open door.
• After installing the Anti-Tip device, verify that it is
in place bg carefullg attempting to tilt the range
forward.
• This range has been designed to meet all
recognized industrg tip standards for all normal
conditions.
• The use of this device does not preclude tipping
of the range when not properlg installed.
• If the Anti-Tip device supplied with the range does
not fit this application, use the universal Anti-Tip
device WB2X7909.
[] Hark the wall where the RIGHT EDGE of the
range isto be located. Be sure to allow for the
countertop overhang if gou intend to install the
range next to cabinets.
of range
[] Locate the outside edge of the device 2Y8"
toward the center of the range from the marked
edge of the range.
[] Using the device as a template, mark the position
of the hole for the screw.
[] For wood construction, drill a pilot hole at an
angle of 20 degrees from the horizontal. A nail or
awl mag be used if a drill is not available.
Mount the Anti-Tip device with the screw provided.
For cement or concrete construction, gou will need
a 1/4"x 1W' lag bolt and a 1/2" O.D.sleeve anchor,
which are not provided. Drill the recommended size
hole for the hardware.
[] INSTALLING THE ANTI-TIP DEVICE
(CONT.}
Wallboard
Anti-Tip
Wood screw
Back of range
Install the sleeve anchor into the drilled hole and then
install the lag bolt through the device. The bolt must
be properlg tightened as recommended for the
hardware.
[] Slide the range against the wall, and check for
proper installation bg grasping the front edge of
the cooktop and carefullg attempting to tilt the
range forward.
WHEN ALL HOOKUPSARE COMPLETED
Hake sure all controls are left in the off position.
Hake sure the flow of combustion and ventilation
air to the range is unobstructed.
CONVERTINGTO LPGAS(or converting back
to natural gas from LP)
This range leaves the factorg set for use with
natural gas. If gou want to convert to LPgas, the
conversion must be performed bg a qualified LP gas
installer.
The conversion instructions and LPorifices can be
found attached to the range next to the pressure
regulator.
Keep these instructions and the orifices in case gou
want to convert back to natural gas.
41
Loading ...
Loading ...
Loading ...