Loading ...
Loading ...
Loading ...
Installation Instructions
[] ADJUST BROIL AND OVEN BURNER
AIR ADJUSTMENT SHUTTERS IF
NECESSARY
To determine if the oven/broiler burner flames are
burning properly, first remove the oven bottom.
To remove the oven bottom:
/
Oven bottom
[] Remove screws holding down rear of oven
bottom.
[] Grasp oven bottom at finger slots on each side.
[] Lift rear of oven bottom enough to clear the lip
of range frame, then pull out.
With the oven bottom removed, properly
adjusted flames should have appro×imately 1"
blue cones and, if range is supplied with natural
gas, should burn with no yellow tipping. (With
most LP gas, small yellow tips at the end of
outer cones are normal.) Flames should not lift
off burner ports. If lifting is observed, gradually
reduce air shutter opening until flames are
stabilized.
The shutter for the oven burner is near the back
wall of the oven and behind the kick panel or
broiler compartment (depending on the model).
Remove the panel or open the broiler. See the
Careand cleaning ofthe range section.
4O
[] ADJUST BROIL AND OVEN BURNER
AIR ADJUSTMENT SHUTTERS IF
NECESSARY(CONT.)
Loosen
Air adjustment shutter
C
Metal shield
(on some models)
Onsome models,remove the metal shieldat the rear
ofthe cavitU.Theair adjustment shutter isbehind this
shield.
Toadjust the flow of air to the burner,loosenthe
Phillips-headscrewand rotate the shutter to allow
more or lessair into the burner tube.
[] LEVELING THE RANGE
[] Installthe oven shelvesin the oven and positionthe
range where itwill be installed.
Raise
rang_ Lower
IJ ' Lower range
range
Leg _ ,A
range
[]
[]
(on some models) (on some models)
Checkfor levelnessby placing a spirit levelor a cup,
partially filledwith water,on one of the oven shelves,If
using a spirit level,take two readings-with the level
placed diagonally first in one direction and then the
other,
Removethe kickpanel or open the broiler
compartment. Seethe Careand cleaningofthe range
section.Thefront levelinglegscan be adjusted from the
bottom and the rear legscan beadjusted from the top
or the bottom.
[] Usean open-end or adjustable wrench to adjust the
levelinglegsuntil the range islevel.
[] After the range islevel,slidethe range away from the
wall sothat the Anti-Tip devicecan be installed.
Loading ...
Loading ...
Loading ...