Weber 22510201 Smokefire Series EX4 (2nd Gen) Wood Fired Pellet Grill

OWNER’S MANUAL - Page 28

For 22510201. Series: Smokefire
Also, The document are for others Weber models: EX4, EX6

PDF File Manual, 36 pages, Read Online | Download pdf file

22510201 photo
Loading ...
Loading ...
Loading ...
28
TROUBLESHOOTING
Replacing the Glow Plug
Contact WEBER Customer Service at weber.com for a replacement glow
plug. To replace the glow plug, please follow these steps:
1. Open the grill lid and shutdown the grill by pushing and holding the
dial or using the main menu. Wait until the grill has completed the
shutdown procedure and completely cooled.
CAUTION: Do not unplug the grill or turn it o during the shutdown procedure.
2. Once the grill has completed the shutdown procedure, power o the
grill (A) and unplug from power source.
3. Open the grill lid and remove the cooking grates, FLAVORIZER bars,
heat diuser, and heat bae from the cookbox. (B).
4. From the rear of your SMOKEFIRE grill, remove the rear access panel
by removing four screws (C).
5. Unplug the glow plug assembly wire by pinching and pulling the
quick disconnect plug (D).
6. Carefully remove the glow plug assembly by removing the bracket
screw that holds it in place and sliding the assembly out from the
grill (E).
7. Remove the glow plug from the glow plug assembly by pulling it out
and away (F).
8. Install the replacement glow plug into the glow plug assembly by
firmly pushing it into the socket (G).
9. Carefully reinstall the glow plug assembly straight through the back
of the grill, and secure it in place by tightening the bracket screw (H).
NOTE: Be sure that the tip of the glow plug has been properly installed by
visually inspecting the glow plug at the bottom of the burn pot inside the
cookbox. The tip of the glow plug must be inserted through the pellet grate for
proper operation (I).
10. Reconnect the glow plug assembly wire connector (J).
11. Reinstall the rear access panel (K).
12. Reinstall the heat bae, heat diuser, FLAVORIZER bars and cooking
grates inside the cookbox. (L).
13. Plug the power cord into the grill located underneath the hopper,
then plug the grill into a power source.
14. Power on the grill and confirm replacement of the glow plug within
the main menu settings of the controller.
A
1
2
3
4
B
C
D
Loading ...
Loading ...
Loading ...