Loading ...
Loading ...
Loading ...
6
GETTING STARTED
INSTALLATION CHECKLIST
✔ Electrical Power
■ Plug refrigerator into a grounded 3 prong outlet.
✔ Doors
■ If doors need to be removed during installation, see “Remove
and Replace Refrigerator Doors” in these instructions.
■ Check that handles are secure and installed according to
these instructions.
■ Doors seal completely.
■ Refrigerator is level. (Remove base grille and adjust leveling
feet so they are snug against the oor.)
■ Doors are even across the top. (Use door alignment feature
if necessary.)
■ Base grille is properly attached to the refrigerator.
✔ Ice and Water System (on some models)
■ Connect refrigerator to a cold water supply with 20-120 psi
water pressure, as specied in these instructions.
■ Make sure the household water supply is connected and
turned on.
■ Check that the water supply line behind refrigerator is not
kinked.
■ Only use recommended water supply tubing, copper, or PEX,
as specied in these instructions.
■ Install water lter according to the instructions.
■ Flush water system with 3 gallons of water, as specied in
these instructions.
■ Check for water leaks at all connections.
■ Turn on ice maker if refrigerator is connected to water supply.
(If not connected to water supply, turn off ice maker.)
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
✔ Final Checks
■ Install air lter according to instructions in corresponding
packaging.
■ Remove all shipping material.
■ Set temperature controls to the recommended setting.
■ Save instructions and other literature.
■ Send in Registration Card or register your product online.
WATER FILTER INSTALLATION
■ Locate the water lter compartment in the lower left-hand
side of the refrigerator compartment. Push on the right side of
the lter door to open.
■ Align the arrow on the water lter cap with the cutout notch in
the lter housing and insert lter.
■ Once the lter is inserted, turn the lter clockwise 90°
(1/4 turn) until it locks into the housing.
■ Push water lter door closed to latch.
■ Flush 3 gallons of water through the water system to clear air
from the water line and to keep the dispenser from dripping
and/or avoiding decreased dispenser ow.
NOTE: If the lter is not installed correctly, water may
dispense at a lower ow rate and there will be slower ice
production. Improper lter installation may also cause the
water lter housing to leak.
DOOR ALIGNMENT
Align Refrigerator Doors
✔ If doors are uneven:
■ Ensure the refrigerator is level.
■ Keeping both refrigerator doors closed, pull out the freezer
drawer. Locate the bottom hinge pin of the right-hand
refrigerator door. The alignment screw is inside the bottom
hinge pin.
■ Insert the short end of the 1/8" (3.18 mm) hex-key wrench
(packed with the Door Handle Installation Instructions) into
the bottom hinge pin until it is fully engaged in the alignment
screw.
To raise the refrigerator door, turn the hex key to the right.
To lower the door, turn the hex key to the left.
Loading ...
Loading ...
Loading ...