Loading ...
Loading ...
Loading ...
18
7. Make sure the refrigerator is steady. If the refrigerator seems
unsteady or rolls forward when a door or drawer is pulled
open, adjust the brake feet.
To Steady the Refrigerator:
■ Open the freezer drawer. Using a 1/4" (6.35 mm) hex
driver, turn both brake feet clockwise the same amount
until the brake feet are snug against the oor. Check
again. If not satised, continue to adjust the brake feet by
half turns of the screw until the refrigerator does not roll
forward when the drawer is opened.
A. Bottom hinge pin
B. 1/8" (3.18 mm) hex-key wrench
3. Move the refrigerator to its nal location.
4. Using the 1/4" (6.35 mm) hex driver, lower the brake feet.
Turn them clockwise until the rollers are off the oor and
both brake feet are snug against the oor. This keeps the
refrigerator from rolling forward when opening the refrigerator
doors or freezer drawer.
IMPORTANT: If you need to make further adjustments
involving the brake feet, you must turn both brake feet the
same amount to keep the refrigerator level.
5. Use a level to make sure the refrigerator is level from side to
side and front to back.
6. Make sure the doors are even at the top and that the space
between the bottom of the refrigerator doors and the top of
the freezer drawer is even. If necessary, align the doors.
To Align the Doors:
■ Keeping both refrigerator doors closed, pull out the freezer
drawer. Locate the bottom hinge pin of the right-hand
refrigerator door. The alignment screw is inside the bottom
hinge pin.
■ Insert the short end of the 1/8" (3.18 mm) hex-key wrench
(packed with the Door Handle Installation Instructions) into
the bottom hinge pin until it is fully engaged in the alignment
screw.
To raise the refrigerator door, turn the hex key to the right.
To lower the door, turn the hex key to the left.
■ Continue to turn the alignment screw until the doors are
aligned.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Replace and Install the Water Filter
The water lter should be replaced every 6 months based on a
ow rate of .50 gpm-.60 gpm that lters 200 gallons of water.
To order a replacement lter, contact us. See the “Accessories”
section in the Use and Care Guide for information on ordering.
1. Push the water lter door to open, located bottom left of
refrigerator compartment.
2. Twist the water lter and turn 90° counterclockwise to unlock.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the brake feet. This makes
it easier to turn the screws. Do not push with excessive force
that tilts the refrigerator.
8. Replace the base grille by aligning the ends of the grille with
the leveling assemblies on each side and snapping the grille
into place. Use a 1/4" (6.35 mm) hex driver to reinstall screws.
FILTERS AND
ACCESSORIES
Water Filtration System
B
A
Loading ...
Loading ...
Loading ...