Loading ...
Loading ...
Loading ...
19
EN
Setting the Water Softening
System
For effective washing performance, adjust the
setting corresponding to the hardness level of
water used in water supply. The water softener
has 5 adjustment levels, and the appliance is
programmed at the factory for a water hardness
level of H0. You can check the default setting
value and adjust it in the following steps:
1
Press Power and Half Load button
simultaneously.
• Current setting value indicated.
2
Press the Delay Start button, and then set
up the intended value.
• Scope of setting value is H0 to H4.
3
Press the Start button to save the setting.
• The power turns off after saving.
NOTE
• The Salt refill icon turns on in the display
if appliance salt is not in the softening system.
• If the hardness setting is set to H0, no icon
indicates in spite of no salt.
Filling with Dishwasher Salt
The Dishwasher Salt tank must be filled before
starting the washing programme. In case of
insufficient salt, the Salt refill icon indicates
on the display, unless the hardness level has
been set to H0.
CAUTION
• Once you have filled with appliance salt you
must run the Rinse cycle immediately to
remove the salt and the salt water around the
inner tub in order to prevent corrosion.
1
Remove the lower rack and remove the cap
of the salt container located on the left side
of the filters.
2
Before using the appliance for the first time,
it is necessary to pour 1.0 kg of appliance
salt and 1 litre of water at the same time if
intending to use the water softener system.
When refilling the salt, use a funnel. Refer
to Before Using the Appliance section.
Salt
Water
3
Refit the cap tightly.
4
Run the Rinse cycle without dishes.
Loading ...
Loading ...
Loading ...