Loading ...
Loading ...
Loading ...
15
EN
Case 1. The Door is Slanted to
the Right
1
Unscrew (counter-clockwise) the rear left
leg and correct the level.
2
Check the opening of door and repeat if
necessary until the door opens and closes
properly.
Slant to the right
Case 2. The Door is Slanted to
the Left
1
Unscrew (counter-clockwise) the rear right
leg and correct the level.
2
Check the opening of door and repeat if
necessary until the door opens and closes
properly.
Slant to the left
Installing the Drain Hose
If the end of the drain hose does not fit to the
drain line, use a drain extension kit (optional)
that is resistant to heat and detergent.
This should be available from a plumbing shop
or a hardware store.
Connection to the Waste Spigot
Check the waste spigot when initially installing.
An OE error can occur when the waste spigot
below the sink is not drilled out properly. To
connect the drain hose, drill out at least a 15
mm diameter hole in the waste spigot before
connecting and securing.
Waste spigot
CAUTION
• Make sure that plastic debris is not remaining
inside of spigot after it has been drilled out.
• Do not attempt to open the waste hole with a
screwdriver and hammer. this will induce
debris to become stuck and cause a
malfunction.
• Caution should be taken when passing hoses
through Cabinetry holes as they may have
sharp edges and could damage the hoses.
Smooth or sand edges to avoid damaging the
drain or inlet hose.
• Make sure that the line is not kinked or
sharply bent.
Loading ...
Loading ...
Loading ...