Loading ...
Loading ...
Loading ...
44 electrolux.com.au
ELECTRICAL & GAS CONNECTION LOCATIONS
Models EFEP915SB
168
95
Electrical connection cable
806
411
Gas connection point to regulator
Models: EFEP915SB
Electrical cable
entry point
Models:
EFEP915SB, EFEP956SB
Installing the gas cooker
Gas pressures
The following table shows the supply and operating
pressures for various gases.
Gas type Natural
gas
Universal
LPG
Supply pressure at inlet
to appliance regulator
1.13 (k Pa)
Minimum
2.75
kPa
Operating pressure at
appliance test point
1.00 (kPa) 2.60 kPa
The following table shows the injector sizes for
each burner.
Injector Orifice Natural gas Universal LPG
Low heat burner 1.00mm 0.55mm
Medium heat burner 1.35mm 0.70mm
High heat burner 1.60mm 0.90mm
Intense heat
dual wok burner
0.85mm
(inner)
2 x 1.25mm
(outer)
0.46mm
(inner)
2 x 0.73mm
(outer)
Checking piping size
To work out a suitable pipe size for connection use the
information in this table:
Model Natural gas Universal LPG
EFEP915SB 52.2 MJ/h 44.9 MJ/h
For information and requirements about construction and
capacity of consumer piping refer to AS5601 series of
standards.
Gas connection
Read these points before connecting to the gas supply:
• The appliance is preset for natural gas use. If LPG is
to be used see Conversion to LPG section.
• Gas installation must be made in accordance with
AS5601, the local gas fitting regulations, municipal
codes and other statutory regulations.
• The gas connection point is a ½” BSP external thread
located at the rear of the appliance as shown.
• A regulator is supplied which must be fitted to the
appliance. Ensure that when fitted the pressure test
point of regulator is accessible.
• The regulator is to be fitted to the manifold inlet at
the rear of the appliance and the connection thread
is sealed using a tape or jointing compound suitable
for gas connections. The consumer piping is then
connected to the inlet of the regulator, either:
1. directly, or
2. using a hose assembly and in accordance with
Clause 6.10.1.9 of AS 5601.1 (High level connection)
together with the supplied elbow. The elbow is
fitted to the inlet of the regulator and oriented to
allow the hose to hang downwards. The connection
thread between the regulator and elbow is sealed
using a tape or jointing compound suitable for gas
connections.
Loading ...
Loading ...
Loading ...