Loading ...
Loading ...
Loading ...
24 electrolux.com.au
Activation and deactivation
Touch
for 1 second to activate or deactivate the
appliance.
Automatic switch off
THE APPLIANCE WILL AUTOMATICALLY
SWITCH OFF IF:
• All cooking zones are deactivated (
).
• You do not set the heat setting after you activate
the appliance.
• You spill something or put something on the
control panel for more than 10 seconds (a pan,
a cloth, etc). An acoustic signal will sound and
the appliance will switch off. Remove the object
or clean the control panel.
• The appliance becomes too hot (e.g. when
a saucepan boils dry). Before you use the
appliance again, wait for the cooking zone to
cool down.
• You use incorrect cookware. The symbol
will
come on and the cooking zone will deactivate
automatically after 2 minutes.
• A cooking zone is on for an extreme length of
time. The symbol
will show and the appliance
will switch off. See below.
• The length of time that various settings can run
for before automatic switch off occurs are
shown below:
•
- 6 hours
•
- 5 hours
•
- 4 hours
•
- 1.5 hours
The heat setting
To adjust the heat setting, place your finger over the heat
bar graphic and slide across. The display will show the
adjusted heat setting.
NOTE: When you use cookware larger than 180mm the
manufacturer recommends that you put it on the rear
cooking zones.
Bridge function
The Bridge function connects two cooking zones together
and then operates them as one. You can use this function
for cookware larger than 260mm.
First set the heat setting for one of the cooking zones.
To activate the Bridge function touch
. The indicator will
then come on. To set or change the heat setting, touch
either one of the control sensors.
To deactivate the Bridge function touch
. The
indicator will go off. The cooking zones will then operate
independently.
Fast heat up function
You can get a required heat setting in a shorter time if
you activate the Fast Heat Up function. This will run the
cooking zone at maximum until the required heat setting
is reached.
To start the Fast Heat Up function for a cooking zone:
1. Touch the power function sensor
( will come on).
2. Immediately touch your required heat setting. After 3
seconds
comes on in the display.
3. The zone will heat at maximum until your required
heat setting is reached. The display will then change
from
back to the required heat setting.
4. To stop the Fast Heat Up function change the
heat setting.
USING THE INDUCTION HOB
Loading ...
Loading ...
Loading ...