Loading ...
Loading ...
Loading ...
37
Installing splashback (Models with hob only)
Fit splashback to rear of hob with three screws
provided.
Cabinet requirements
Models EFEP955SB & EFEP915SB are designed to
fit into a 900mm wide gap between standard kitchen
cabinets. The appliance integrates with the kitchen
cabinets by matching the height, depth and kick
panel. The cooker may also be installed at the end of
a line of benches or with a free space either side. In
addition, a slot-in type installation is catered for allowing
a continuous cabinetry kick panel to be used. Model
EVEP916SB is designed to be built into cabinetry either
below a benchtop or into a vertical cabinet.
WARNING!
• The cooker must be installed and serviced only by
an authorised person.
• A Certificate of Compliance MUST be supplied to
be kept by the customer.
• The packing materials must be removed before
you install the cooker.
• The surrounding kitchen cabinets must be able
to withstand 85°C. Electrolux WILL NOT accept
responsibility for damage caused by installation
into kitchen cabinets which cannot withstand
85°C.
• The pipes used for installation MUST have
sufficient loops so the cooker can be moved for
service
(gas model).
• The vents, openings and air spaces MUST NOT
be blocked.
• The anti-tilt brackets and chain or front stops
MUST be installed to avoid accidental tipping
(freestanding and slot-in models).
• You MUST NOT lift or pull the cooker by the
door handle.
• The cooker MUST be checked every five years.
• The appliance must not be installed behind a
decorative door in order to avoid overheating.
Gas model clearance requirements
• Ensure the appliance is installed in accordance
with clauses 6.2.5 and 6.10.1.1 of AS/NZS 5601.1
or clauses 6.9.1 and 6.9.5 of AS/NZS 5601.2 with
regard to clearances to combustible surfaces and
materials, and clearances to rangehoods and
exhaust fan. To ensure clearances of 200mm from
burners to vertical combustible surfaces observe the
minimum dimension of 100mm from each side of the
cooker to combustible surfaces.
• Clearances to combustible surfaces may be reduced
if combustible surfaces are protected in accordance
with clause 6.10.1.2 of AS/NZS 5601.1, or clause 6.9.2
of AS/NZS 5601.2.
• When setting the cooker height, ensure the top of
the cooker is at least 10mm higher than the level
of the benchtop.
INSTALLATION OF THE EFEP955SB & EFEP915SB
Loading ...
Loading ...
Loading ...