Loading ...
Loading ...
Loading ...
Suspension
(cont’d)
Servicing Your Honda 109
12. Clean the surfaces where the axle and axle
clamps contact each other.
Apply grease to each dust seal lips (19) of the
front wheel.
Install the left side collar (20) and right side
collar (21) into the wheel hub.
13. Install the front wheel between the fork legs
while inserting the disc between the pads,
being careful not to damage the pads.
14. Insert the front axle shaft (22) through the
forks and wheel hub from the right side. Make
sure that the front axle shaft is seated firmly
onto the left fork leg clamp inner surface.
Tighten the front axle nut (23) to the specified
torque:
65 lbf·ft (88 N·m, 9.0 kgf·m)
Tighten the left axle pinch bolts (24) to the
specified torque:
15 lbf·ft (20 N·m, 2.0 kgf·m)
15. Install the handlebar (25), mounting rubbers,
washers and handlebar lower holder nuts (26)
and tighten the handlebar lower holder nuts to
the specified torque:
32 lbf·ft (44 N·m, 4.5 kgf·m)
16. Install the number plate (27) by aligning its tab
(28) with the slit (29) on the front fender.
Install the number plate bolts (30), then tighten
the number plate bolts to the specified torque:
7 lbf·ft (10 N·m, 1.0 kgf·m)
Route the number plate tab (31) around the
handlebar (32) as shown. Make sure that the
brake hose (13) is routed properly in front of
the number plate.
17. With the front brake applied, pump the fork up
and down several times to seat the axle and
check front brake operation.
(19) dust seal lips (21) right side collar
(20) left side collar
(20)
(21) (19)(19)
(22) front axle shaft
(23) front axle nut
(24) left axle pinch bolts
(25) handlebar
(26) mounting rubbers, washers and handlebar lower
holder nuts
(23)
(24)
(22)
(26)
(25)
(13) brake hose (30) number plate bolts
(27) number plate (31) number plate tab
(28) tab (32) handlebar
(29) slit
(31)
(13)
(32)
(27)
(28)
(29)
(30)
Loading ...
Loading ...
Loading ...