Loading ...
Loading ...
Loading ...
en Troubleshooting
50
Errors Cause Troubleshooting
Water marks on plastic parts. Due to laws of physics droplet
formation on plastic surfaces
is unavoidable. After drying
water marks are visible.
▶
Select a more intensive programme.
▶
Position tableware at an angle.
→"Arranging tableware", Page35
▶
Use rinse aid.
→"Rinse aid", Page31
▶
Set the water softening system
higher.
Wipeable or water-soluble
coatings are present inside
the appliance or on the door.
Detergent substances are de-
posited there. These coatings
cannot generally be removed
with chemicals.
▶
Change your detergent →Page32.
▶
Clean the appliance mechanically.
White coating is deposited in
the appliance interior.
1. Set the water softening system cor-
rectly.
In most cases you will need to in-
crease the setting.
2. Change your detergent if required.
Special salt dispenser is not
screwed tight.
▶
Screw the special salt dispenser tight.
Stubborn white coatings are
present on tableware, inside
the appliance or the door.
Detergent substances are de-
posited there. These coatings
cannot generally be removed
with chemicals.
▶
Change your detergent →Page32.
▶
Clean the appliance mechanically.
The hardness range is set in-
correctly or the water hard-
ness is greater than 62°°E
(8,9mmol/l).
▶
Set the Water softening system
→Page28 to the water hardness or
add special salt.
3in1/organic/eco detergent is
not effective enough.
▶
Set the Water softening system
→Page28 to the water hardness
and use separate detergents (propri-
etary detergent, special salt, rinse
aid).
Too little detergent is being
used.
▶
Increase the amount of detergent
used or change Detergent
→Page32.
Washing programme selected
too weak.
▶
Select a more intensive washing pro-
gramme.
▶
Adjust the sensitivity of the sensors.
Tea residue or lipstick marks
on tableware.
Washing temperature is too
low.
▶
Select a programme with a higher
washing temperature.
Loading ...
Loading ...
Loading ...