Loading ...
Loading ...
Loading ...
en Troubleshooting
48
Errors Cause Troubleshooting
Tableware is not dry. Tableware removed too early
or drying process not yet
ended.
1. Wait until the programme ends.
2. Only remove tableware 30minutes
after the programme has ended.
Rinse aid used has a limited
drying performance.
▶
Use a name-brand rinse aid.
Eco products may have limited effect-
iveness.
Appliance door does not open
automatically at the end of the
Eco 50° programme
▶
Adjust the appliance door as de-
scribed in the installation instructions.
The door gap must be at least 70mm
- 100mm.
Plastic tableware is not dry. Not a fault. As plastic does not
store heat so well, it also does
not dry as well.
▶
No remedial action possible.
Cutlery is not dry. Cutlery not arranged properly
in the cutlery basket or cutlery
drawer.
1. Arrange the cutlery properly.
→"Arranging tableware", Page35
2. Arrange cutlery individually where
possible.
3. Avoid points of contact.
Appliance interior still wet
after wash cycle.
Not a fault. The condensation
drying principle causes water
droplets in the tub – they are
indeed desirable here. The
moisture in the air condenses
on the inside walls, runs off
and is pumped out.
No action required.
Remnants of food on table-
ware.
Tableware was placed too
close together.
1. Arrange tableware with sufficient
space in between.
The spray jets must reach the sur-
faces of the tableware.
2. Avoid points of contact.
Basket is overfilled. 1. Arrange tableware with sufficient
space in between.
The spray jets must reach the sur-
faces of the tableware.
2. Avoid points of contact.
Spray arm rotation is blocked.
▶
Arrange tableware so that it does not
obstruct spray arm rotation.
Spray arm nozzles are
blocked.
▶
Clean the Spray arms →Page43.
Loading ...
Loading ...
Loading ...