Loading ...
Loading ...
Loading ...
MAINTENANCE AND SERVICE
}}
579
CAUTION
Avoid waxing and polishing plastic and rubber.
If using degreaser on plastic and rubber, only
rub (if necessary) with slight pressure. Use a
soft sponge.
Polishing glossy trim moldings can wear away
or damage the glossy surface layer.
Polish containing abrasives must not be used.
CAUTION
Only use paintwork treatments recommended
by Volvo. Other treatments, such as preserva-
tion, sealing, protection, luster sealing or simi-
lar, could damage the paintwork. Paintwork
damage caused by such treatments are not
covered by Volvo's warranty.
Related information
•
Cleaning the exterior (p. 578)
•
Hand washing (p. 579)
•
Automatic car washes (p. 580)
•
High-pressure washing (p. 581)
•
Cleaning the wiper blades (p. 582)
•
Cleaning exterior plastic, rubber and trim
components (p. 582)
•
Cleaning rims (p. 583)
•
Corrosion protection (p. 584)
Hand washing
The vehicle should be washed as soon as it
becomes dirty. This makes the vehicle easier to
clean because dirt does not attach as strongly. It
also reduces the risk of scratches and keeps the
vehicle looking new. Wash the vehicle in a car
wash or garage with an oil separator. Use a car
washing detergent.
Hand washing
Keep the following points in mind when washing
the vehicle:
•
Avoid washing the vehicle in direct sunlight.
This could cause the detergent or wax to dry
out and become abrasive.
•
Remove bird droppings from paintwork as
soon as possible. They contain chemicals
that affect and discolor paint very quickly.
Use e.g. soft paper or a sponge soaked in
lots of water. Consult an authorized Volvo
workshop for assistance removing discolora-
tion.
•
Hose down the underbody, including the
wheel housings and bumper.
•
Hose down the entire vehicle and remove
any loose dirt, droppings etc. to reduce the
risk of scratches from washing. Do not spray
directly onto locks.
•
If necessary, use cold degreaser on heavily
soiled surfaces. Note that in such cases the
surfaces must not be hot from the sun.
•
Wash using a sponge, car washing detergent
and plenty of lukewarm water.
•
Clean the wiper blades with lukewarm soap
solution or car washing detergent.
•
Dry the vehicle using a clean, soft chamois or
a squeegee. Try not to let drops of water dry
in strong sunlight. This could cause water
drying stains that may need to be polished
out.
•
In areas with heavy industrial emissions,
more frequent washing of the vehicle's exte-
rior is recommended.
•
Tar spots from asphalt may remain even after
washing. Use a tar remover to remove these
spots after washing the vehicle.
WARNING
Always entrust engine washing to a workshop.
If the engine is hot, there is a risk of fire.
CAUTION
Dirty headlights do not work as well. Clean
them regularly, e.g. when refueling.
Do not use corrosive cleaners. Use water and
a non-abrasive sponge.
Loading ...
Loading ...
Loading ...