Loading ...
Loading ...
Loading ...
Operation
Assembly of the ball-headed bar
Fig. 198 Placing the ball-headed bar/locking
and r
emo
v
ing the key.
Fig. 199 Placing the key slot cover.
–
Remove the cap from the clamping bush
4
››› Fig. 195 by p
ulling downwards.
–
Place the ball-headed bar in the service po-
sition ››
› page 189.
–
Hold the ball-headed bar from underneath
››› Fig. 198 and push it into the clamping
bush as far as possible until you hear it
click into place ›››
.
The m
anual
r
egulator
A
aut
omatically turns
in the op
po
site direction, adjusting to the
ball-headed bar ›››
.
–
Switch off the manual regulator lock with
k
ey
B
by turning the key fully to the right
in the dir
ection of
arr
ow
1
– the arrow in
the k
ey
di
splays the “locked” symbol.
–
Remove the key in the direction of arrow
2
.
–
Place cover
C
over the manual regulator
loc
k
in the dir
ection of arrow
3
›
›
› Fig. 199
.
–
Verify the correct placement of the ball-
headed bar ››› page 191.
WARNING
●
Do not hol
d the manual regulator with your
hand when fitting the ball-headed bar since
you could sustain injuries to your fingers.
●
When mounting the ball-headed bar, al-
ways lock it with a key and remove the key
from the slot.
●
The ball-headed bar must not be in the
service position with the key in the key slot.
●
If the ball-headed bar is not placed in the
service position you will not be able to place
it in the clamping bush.
CAUTION
When removing the key, always place the
cov
er over the key slot of the manual regula-
tor to prevent dirt from entering.
Note
Once removed, place the clamping bush cap
in an appropri
ate location in the boot.
190
Loading ...
Loading ...
Loading ...