Loading ...
Loading ...
Loading ...
Operation
Switching on side lights
–
Turn the light switch ›
›
›
Fig. 129 to position
.
Switching on dipped beam
–
Turn the light switch ››› Fig. 129 to position
.
Switching off lights (except daytime driving
lights)
–
Turn the light switch ››› Fig. 129 to position
0.
Main light range control
Fig. 130 Instrument panel: light range con-
tr
o
l
.
–
Turn the control ›
›
›
Fig. 130 to set the lights
to the required setting.
Positions
The control positions roughly correspond to
the following vehicle load conditions.
Two front occupants, luggage compart-
ment empty.
All seats occupied, luggage compartment
empty.
All seats occupied, luggage compartment
fully loaded.
Driver only, luggage compartment fully
loaded.
CAUTION
Always adjust the range of the lights so that:
●
Your vehicle does not dazzle others, partic-
ularly
oncoming traffic
●
The range of the headlights is sufficient for
safe driving
Note
Make sure you set the range of the main
lights when the dip
ped beam headlights are
switched on.
Daytime running lights
Daytime running lights are signalling devices
f
or impr
o
ving road safety. The lights are built
into the headlights and come on each time
the ignition is turned on if the light switch is
-
1
2
3
in position 0 or
›
›
› Fig. 129. It is automat-
ically switched off when the side lights are
turned on.
Switching the daytime driving lights on
●
Remove the key from the ignition, move the
turn signal lever upward (right turn signal),
press it back to flash position and hold it
there.
●
Insert the key and switch on the ignition,
holding it in this position for 3 seconds.
Then, switch off the ignition. The daytime
running light is now activated and the corre-
sponding lights can come on.
Switching the daytime running light off
●
Remove the key from the ignition, press the
turn signal lever down (left turn signal), press
it back to flash position and hold it here.
●
Insert the key and switch on the ignition,
holding it in this position for 3 seconds.
Then, switch off the ignition. The daytime
running light is now deactivated and the cor-
responding lights cannot come on.
OR: activate and deactivate the daytime
lights using the Easy Connect system
›››
page 20.
Automatic control of the dipped beam in
combination with the daytime running lights
If the dipped beam control and the daytime
running lights are activated at the same
122
Loading ...
Loading ...
Loading ...