Seat Toledo 2015 Car

OWNER'S MANUAL - Page 187

For TOLEDO 2015.

PDF File Manual, 248 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
Towing bracket device
shown for approximately 5 seconds, and de-
pendin
g on the c
a
se, is repeated. The system
stores the last message displayed.
The message on the instrument panel display
can be switched off by pressing the

button on the windscreen wiper lever or the
b
utt
on

on the multi function steering
wheel
page 22.
The message can be recalled to the instru-
ment panel display using the multifunction
display
page 22.
Conditions of operation
Driving behaviour is only calculated on
speeds above about 65 km/h (40 mph) up to
around 200 km/h (125 mph).
Switching on and off
Tiredness detection can be activated or deac-
tivated in the Easy Connect system with the
button

and the function button

page 104. A mark indicates that the ad-
ju
stment has been activated.
System limitations
The Tiredness detection has certain limita-
tions inherent to the system. The following
conditions can limit the Tiredness detection
or prevent it from functioning.
At speeds below 65 km/h (40 mph)
At speeds above 200 km/h (125 mph)
When cornering
On r
oads in poor condition
In unfavourable weather conditions
When a sporty driving style is employed
In the event of a serious distraction to the
driver
Tiredness detection will be restored when the
vehicle is stopped for more than 15 minutes,
when the ignition is switched off or when the
driver has unbuckled their seat belt and
opened the door.
In the event of slow driving during a long pe-
riod of time (below 65 km/h (40 mph) the
system automatically re-establishes the tired-
ness calculation. When driving at a faster
speed the driving behaviour will be recalcula-
ted.
Towing bracket device
Driv
in
g w
ith a trailer
Technical requirements
If your vehicle has a factory-fitted towing
brack
et or is equipped with a selection of
SEAT Original Accessories, it meets all the rel-
evant technical and legal requirements.
In vehicles with a towing bracket it is possi-
ble to remove the ball joint, situated (togeth-
er with the special assembly instructions) in
the housing for the spare wheel in the vehi-
cle luggage compartment
page 75, Vehicle
tool kit*.
Your vehicle is fitted with a 13-pole power
socket for the electrical connection between
the trailer and the vehicle. If the trailer you
are going to use has a 7-pin connector, the
corresponding adaptor, acquired from the
SEAT Original Accessories Catalogue, can be
used.
If a towing bracket is to be retro-fitted to the
car, it must be done according to the instruc-
tions of the towing bracket manufacturer.
Note
Any queries that may arise can be directed to
an authorised SEA
T dealer.
185
Technical dataAdviceOperationEmergenciesSafety
Loading ...
Loading ...
Loading ...