Loading ...
Loading ...
Loading ...
15
INSTALLATION
EN GLI SH
I nstalling th e A nti- tip Dev ice
Anti-tip
bracket
Leveling
leg
W A RN I N G
T ip - O v er H azard
A child or adult can tip the range and
be killed. V erify the anti-tip bracket
has been installed. Ensure the anti-tip
bracket is engaged when the range
is moved. D o not operate the range
without the anti-tip bracket in place.
Failure to follow these instructions
can result in death or serious burns to
children and adults.
To check that leveling leg is
inserted into anti-tip bracket,
grasp the top rear edge
of the range and carefully
attempt to tilt it forward.
Wall plate
Anti-tip
bracket
Screw must
enter wood or
concrete
Locate th e anti- tip bracket using th e template
An anti-tip bracket is packaged with the template.
The instructions include necessary information to
complete the installation. Read and follow the range
installation instruction sheet (template).
Lev eling th e Range
Level the range by adj usting the leveling legs with a
wrench. Ext ending the legs slightly may also make it
easier to insert the rear leg into the anti-tip bracket.
U se a level to check your adjustments. Place the level
diagonally on the oven rack, and check each direction
for level.
First check direction
.
Then check direction
. If the level doesn’ t show level
on the rack, adj ust the leveling legs with a wrench.
1
2
Connecting Electricity
Electrical Req uirements
This appliance must be installed and grounded on a
branch circuit by a q ualified technician in accordance
with the National Electrical code ANSI/ NFPA NO. 7 0 -
latest edition.
All wiring should conform to Local and NEC codes.
This range req uires a single-phase, 3 wire, A.C
1 20 / 20 8 V or 1 20 / 240 V 6 0 Hz electrical system. U se
only a 3-conductor or a 4-conductor U L-listed range
cord with closed-loop terminals, open-end spade
lugs with upturned ends or similar termination. D o not
install the power cord without a strain relief.
A range cord rated at 40 amps with 1 20 / 240
minimum volt range is req uired. If a 50 amp range
cord is used, it should be marked for use with 1
3
/
8
"
diameter connection openings. This appliance
may be connected by means of a conduit or power
cord. If a conduit is being used, go to page 1 8 for
3 w ire conduit connections or 4 w ire conduit
connections.
Loading ...
Loading ...
Loading ...