Loading ...
2
Quick User Guide
Important notes to help you get a quick start.
Warning:If WINBOT is used to clean a window above ground level, the Safety Pod MUST be
used.
WINBOT must be used in strict accordance with the directions in the Instruction Manual.
ECOVACS can not be held liable or responsible for any damages or injuries caused due to
improper use.
1. Make sure that there is enough power cord for the WINBOT to clean the entire window without restricting
its movement. If there is not enough cord, it is not safe to use the WINBOT on that particular window until a
WINBOT Extension Cord is attached.
2. Loop one end of the Safety Rope around the Safety Pod's channel and pull it tight.
3. Loop the other end of the Safety Rope to the power connector on the power cord and tighten.
4. If an Extension Cord is attached, the Safety Rope must be tied to the power connector on the Extension
Cord.
Note: Do NOT attach the Safety Rope to the thin part of the cord.
5. Press the Safety Pod suction cup FIRMLY in the lower corner on the opposite side of the glass you are
cleaning. Make sure the Safety Pod suction cup is securely in place.
6. Place WINBOT on the window, close the window if cleaning the outside of the window, and start WINBOT.
7. After WINBOT is done cleaning remove it from the window. Grasp the handle, switch the unit OFF, insert
finger into Air Release Trigger and pull up on it for 20 seconds until suction has diminished.
1. Important Safety Instructions
1.1 Should you be cleaning the outside of the window, you must use the Safety Pod. Read the instructions
on SAFETY ROPE use in your Instruction Manual.
1.2 When removing the WINBOT, grasp the handle of the unit and move the switch under the handle to
the left - OFF position, and while still grasping the unit, insert finger into the Air Release trigger and
Pulling up on it, remove the unit from the window when the suction has diminished.
1.3 Place the WINBOT horizontally on the window and about 10cm (4‘’) from the lower corners of the
window
1.4 The unit may NOT be used outside while raining, snowing or colder than 5
℃
(40
℉
) as it will
damage the product and could cause electrical problems.
2. PREPARATION BEFORE USE
1.1 Before charging, please firstly turn on the button at the bottom of the WINBOT. (“ ” OFF “
” ON. The default state is “ ”) Otherwise, WINBOT can NOT be charged or working.
1.2 Plug the adapter into your electrical receptacle and assemble the two connectors, tightening the nut so
the connector will not pull apart. Place the WINBOT’s switch button, located under the handle, in the
Loading ...
Loading ...
Loading ...