Loading ...
Loading ...
Loading ...
12
window, move the switch to the ON position and only let go once the unit has securely attached itself to
the window being indicated by the Indicator Light flashing BLUE in color. At this point, you should remove
your hand from the unit. When Indicator Light do NOT light, it means the suction power in too small.
Please check or replace the cupule. When Indicator Light flashes red, please adjust the height of
placement and restart the product.
With the Safety Pod attached to the inside of the window, close the window without damaging the outer
skin of the Supply Cord. Make sure there is enough cord between the Safety Pod and the WINBOT for the
unit to clean the entire window without restricting its movement.
4.2 Product Start
Once the unit is attached to the outside of the window, press the Start Button on the unit or the
Start/Pause button on the Remote. The product will use its automatic cleaning mode to clean the
window and return to the position (which is near the start point) after having cleaned the window.
NOTE:
This product is intended for cleaning dust on common home windows. WINBOT can NOT be used to
clean stains such as painting, glue, etc. WINBOT can NOT be used to remove items such as chewing
gum, label, papers, etc which may cause suction failure.
Glass with uneven surface, such as frosted, textured, patterned or leaded is not suitable to be cleaned
by the WINBOT.
After WINBOT has finished cleaning one window, if the cleaning pads are too dirty, please replace them
with a clean set.
The unit may NOT be used outside while raining, snowing or colder than 5℃ (40℉) as it will damage
the product and could cause electrical problems.
Should the unit stop working and the Indicator Light blink RED, you need to respond by grasping the
handle of the unit and turn the switch OFF. You may then turn the switch back ON and press the
Pause/Start button to start the cleaning process.
4.3 Product Pause
If you want to Pause the product during the cleaning process, press the “Start/Pause” (Icon) button on
the Remote Control momentarily or press the “Start/Pause” (Icon) button on the unit. The product will
pause and wait for further instructions.
While the unit is in the Pause Mode, you may use the Remote to move the unit around the window by
pressing the appropriate directional arrow. This is handy for your use when a spot on the window is
difficult to clean, because you can move the unit back to the spot and clean again. When you want to
return the unit to the Auto Mode to continue cleaning, press the pause button on the Remote.
If using WINBOT for a long period of time continuously, give yourself and WINBOT a 10 minutes break for
every hour of use, this will extend the life and performance of robot and avoid overheating.
4.4 Product Stop
After the product has finished cleaning the window, it will return to the place where you had started the
cleaning. If you find the stopping place is not convenient for you to grasp to remove the unit, use the
Loading ...
Loading ...
Loading ...