Loading ...
Loading ...
Loading ...
15
Pay attention to the maintenance requirements of the unit as spelled out in that section of the
Instruction Manual.
7. Product Maintenance
7.1 Cleaning the Unit
The Unit must be in the OFF position and unplugged from the electrical source.
The Unit may NOT be cleaned with any volatile liquid such as solvent, gas, etc. or a detergent containing acidic
or pine sole additives as they will negatively affect the plastic.
7.2 Cleaning and Replacing Cleaning Cloth
After each cleaning or should the Pad get really dirty before finishing the cleaning of the window, the Pad can
be rinsed in clear warm water. Be careful of detergent you might use to wash the pad as you do not want to
leave a soapy film on the pad that will not allow the Pad to properly clean the window. After thoroughly dried
(generally dry for 24 hours), re-install the pad on the unit.
7.3 Squeegee
Squeegee maintenance
After each use, gently wipe the Squeegee with a damp cloth to remove residue from its surface. A wet cloth
will allow water to get inside the unit and cause damage to the internal components. A replacement
squeegee may be purchased by going to our Web Site or calling our service number.
Squeegee replacement
1 Push the Squeegee to the center from each end of the Squeegee, then take it off.
2 Replace it with a new one: put the new one into the groove and pull the end of the Squeegee to each side.
7.4 Cleaning Driving Treads
After each use inspect the Treads for possible accumulation of dirt. The total tread can be inspected by using
the remote and pressing the Forward or Reverse arrow. Clean any dirt with a soft damp pad.
NOTE: Dirty treads can negatively affect the function of the treads driving the unit on the window.
7.5 Cupule
Cupule maintenance
The Cupule assembly is a basic part of the units function and is located on the bottom of the unit. After each
use, you need to inspect the cupule’s surface to make sure it is not torn or cut. Any debris that is stuck to the
surface must be carefully removed.
Cupule replacement
1 Take the cupule off with a screw driver.
2 Replace it with a new one.
7.6 Extension Cord
Extension Cord is used to extend WINBOT's working range. If your window is too large, this will be a perfect
choose. For the use of Extension Cord, please see the following picture.
Meaning of Indicators
NO.
Sound
Indicator Light
Meaning
Loading ...
Loading ...
Loading ...