Loading ...
Loading ...
Loading ...
13
Remote by pressing the appropriate directional arrow until the unit is where you can grasp the handle
more conveniently.
Holding the handle of the unit, move the switch to the OFF position, to the far left, and place finger in the
Air Release slot and lifting with your finger, you will release the vacuum from the inner circle. In a few
seconds, the unit will be free from the window.
If you do NOT use the Air Release button, you need to hold the handle for about 45 to 60 seconds. Do
NOT try to use the handle as leverage to pry the unit from the window as you could damage the product.
After removing the unit from the window, do the required maintenance on the product in preparation for
storage. BEFORE storing, while the unit is plugged into your receptacle, move the switch to the Charge
position and allow the battery to charge until the Green light quits Flashing.
Always Store the unit with the switch in the OFF position.
4.5 Product Restart
When the product cycles a place repeatedly during the operation, or stops working, sending a warning prompt
and the red indicator light flashing, grasp the unit by the handle and turn the switch to the OFF position.
Then, turn the unit back ON and press the Pause/Start button on the unit to continue the cleaning process.
5. Accessories
5.1 Safety Pod
Warning:If WINBOT is used to clean a window above ground level, the Safety Pod MUST be
used.
WINBOT must be used in strict accordance with the directions in the Instruction Manual.
ECOVACS can not be held liable or responsible for any damages or injuries caused due to
improper use.
1. Make sure that there is enough power cord for the WINBOT to clean the entire window without restricting
its movement. If there is not enough cord, it is not safe to use the WINBOT on that particular window until a
WINBOT Extension Cord is attached.
2. Loop one end of the Safety Rope around the Safety Pod's channel and pull it tight.
3. Loop the other end of the Safety Rope to the power connector on the power cord and tighten.
4. If an Extension Cord is attached, the Safety Rope must be tied to the power connector on the Extension
Cord.
Note: Do NOT attach the Safety Rope to the thin part of the cord.
5. Press the Safety Pod suction cup FIRMLY in the lower corner on the opposite side of the glass you are
cleaning. Make sure the Safety Pod suction cup is securely in place.
6. Place WINBOT on the window, close the window if cleaning the outside of the window, and start WINBOT.
7. After WINBOT is done cleaning remove it from the window. Grasp the handle, switch the unit OFF, insert
finger into Air Release Trigger and pull up on it for 20 seconds until suction has diminished.
Loading ...
Loading ...
Loading ...