Loading ...
Loading ...
Loading ...
Emergencies
Note
●
Obser
ve legal requirements when towing or
tow-starting.
●
Switch on the hazard warning lights of both
vehicles. However, observe any regulations
to the contrary.
●
For technical reasons, vehicles with an au-
tomatic gearbox must not be tow-started.
●
If there is no lubricant in the gearbox as the
result of a fault, you must raise the driven
wheels while the vehicle is being towed.
●
If the vehicle has to be towed more than
50 km (30 miles), the front wheels should be
raised during towing, and towing should be
carried out by a qualified person.
●
The steering wheel is locked when the vehi-
cle has no electrical power. The vehicle must
then be towed with the front wheels raised.
Towing should be carried out by a qualified
person.
●
The towline anchorage should always be
kept in the vehicle.
Towline anchorages
Fig. 87 Towline anchorage at the front of the
v
ehic
l
e
Read the additional information carefully
›
›
›
page 51
Fitting the front towline anchorage
–
Take the towline anchorage from the on-
board tool set.
–
Remove the front cover by pressing down
on its left-hand side. For FR finishes, press
down and pull outwards. For the rest of the
Sport finishes, remove the cover by insert-
ing a screwdriver into the lower slot and
levering gently.
–
Bolt the anchorage to its limit to the left, in
the direction of the arrow ››› Fig. 87.
Rear towline anchorage
There is a towline anchorage at the rear on
the right below the rear bumper.
Fuses and bulbs
F
u
se
s
Introduction
Due to the constant updating of vehicles,
fuse a
ssignments based on equipment and
the use of the same fuse for various electrical
components, it is not possible to provide an
up-to-date summary of the fuse positions for
the electrical components at the time this
manual was printed. For detailed information
about the fuse positions, please consult a
technical service.
In general, a fuse can be assigned to various
electrical components. Likewise, an electrical
component can be protected by several
fuses.
Only replace fuses when the cause of the
problem has been solved. If a newly inserted
fuse blows after a short time, you must have
the electrical system checked by a special-
ised workshop as soon as possible.
WARNING
The high voltages in the electrical system can
give serious
electrical shocks, causing burns
and even death!
●
Never touch the electrical wiring of the igni-
tion system.
80
Loading ...
Loading ...
Loading ...