Loading ...
Loading ...
Loading ...
Operation
●
Pr
e
s
s the
AUTO
button
13
›
›› Fig. 155
.
●
Adju
st vents 3 and 4 ››› page 138 so that
the air flow is directed slightly upwards.
Change between degrees Centigrade and de-
grees Fahrenheit
Keep the
AUTO
and
A/C
›
›› Fig. 155
b
uttons
held down for 2 seconds at the same time.
The data is displayed on the screen in the
units required.
Note
●
A vi
sit to the specialised service once a
year is recommended to clean the Climatronic
system.
●
The interior temperature sensor
11
››› Fig. 155 is at
the bottom. Do not cover it
with stickers or the like, as this could have a
negative effect on Climatronic operations.
Automatic mode
Automatic mode is used to maintain a con-
s
t
ant
temperature and demist the windows
inside the vehicle.
Switching on automatic mode
●
Set the interior temperature between +16°C
(+64°F) and +29°C (+84°F).
●
Adjust vents 3 and 4
›››
page 138 so that
the air flow is directed slightly upwards.
●
Press the
AUTO
button
13
›
›› Fig. 155
and
AUTO di
splayed on the screen.
Automatic mode is switched off by pressing
the air distribution buttons or increasing or
decreasing the blower speed. However, the
temperature remains regulated.
Adjusting the temperature
●
When you switch on the ignition, control
1
››› Fig. 155 can be used t
o set the required in-
terior temperature.
It is possible to select interior temperatures
from +16°C (+64°F) to +29°C (+84°F). In this
range the temperature is regulated automati-
cally. If a temperature below +16°C (+64°F) is
selected, “LO” is displayed on the screen. If a
temperature above +29°C (+84°F) is selected,
“HI” is displayed on the screen. At both ex-
tremes, Climatronic works at maximum cool-
ing or heating power, respectively. The tem-
perature is not regulated.
In the event of prolonged, irregular distribu-
tion of the air flow from the outlets (particu-
larly the footwells) and significant differen-
ces in temperature, e.g. on leaving the vehi-
cle, sensitive people may catch cold.
Air recirculation
Air recirculation prevents unpleasant smells,
e.g. when pa
ssing through a tunnel or in
queuing traffic, from entering the interior.
Switching on air recirculation mode
●
Press button
17
››› Fig. 155 and the
symbol is displayed on the screen.
Switching off air recirculation mode
●
Press button
17
›
›
› Fig. 155
and the
symbol disappears from the screen.
WARNING
Read and observe the safety warnings ›››
in
General
notes on page 137.
Note
If air recirculation mode remains on for 15 mi-
nutes, the
symbol will start to flash on
the screen to indicate prolonged air recircula-
tion. If air recirculation is not switched off,
the symbol will continue to flash for about 5
minutes.
Blower selection
Climatronic automatically regulates blower
s
peed ac
c
ording to the interior temperature.
144
Loading ...
Loading ...
Loading ...