Loading ...
Loading ...
Loading ...
24 www.electrolux.com
Rell the tanks with the same
detergent and fabric softener as
before. If changing either of the liquid
detergents, clean the tanks before
relling (see section 8.5 for instructions
on how to clean the tanks).
If the tanks are lled before the
appliance is powered on for the rst
time, the AutoDose indicator will not
blink.
When the activated tank reaches a low level
of detergent,
indicator blinks slowly and
continuously on the display.
It will stop blinking when the compartment
is relled.
If tank is not relled, once a program has
started, the indicator will stop blinking and
stay steadily lit. Once the program is n-
ished, it will start blinking again.
Unless AutoDose is turned OFF, if a com-
partment has reached low level, the set dos-
age for that compartment will be shown by
the display for a few seconds each time the
drawer is opened, to remind rell is needed.
If in both tanks detergent level is low, both
indicators blink, but only the set dosage for
detergent will be displayed.
5. Press Softener touchpad to select
congure softener dosage.
Touch the “Temp” touchpad repeatedly to
increase and “Spin” touchpad to reduce.
Minimum step is 1 ml (you can press and
hold touchpad to increase the increment
to 10ml/step).
6. To save and exit conguration mode,
press and hold “Temp” and “Spin”
touchpads combination again for 3
seconds or you can turn the knob to any
position.
Do not rell the AutoDose tanks
unless appliance indicates that one or
both tanks are empty.
AutoDose low level indication
Manual lling the detergent
and additives
You may need to use a different
detergent or fabric softener than the
ones used in the AutoDose tanks. First,
make sure that the AutoDose tanks are
disabled and then pour the detergent,
fabric softener or other treatments in the
manual compartments.
1. Open the detergent dispenser.
2. Lift out the special container for liquid
detergent.
We recommend that you do not
exceed the maximum indicated
level (
).
Drawer open indication
When a program is running, the detergent
drawer must always be closed.
A sensor in the drawer detects if the
drawer is open (or not properly closed)
while the program is running. In such case,
the appliance will immediately be paused.
If you press the Start/Pause
touchpad,
an error sound is generated and
everything in the display will turn off
except the AutoDose symbols (
and
) remain lit for a few seconds. Then
the display returns to the previous paused
state. This will happen even if AutoDose is
turned off.
To restart the program, ensure the drawer
is properly closed and press Start/Pause
touchpad.
Loading ...
Loading ...
Loading ...