Loading ...
Loading ...
Loading ...
Black plate (397,1)
北米Model "A1160BE-C" EDITED: 2014/ 3/ 17
17. Remove the compressor hose (2) from
the application cap (6).
18. Connect the valve fitting (9) on the tip
of the application cap’s rubber hose (8) to
the other side of the application cap (5) to
prevent the remaining sealant from leak-
ing out.
CAUTION
Be careful that sealant does not leak
onto skin or fabric.
19. Put away the flat tire repair kit.
20. Immediately begin driving your vehicle
for approximately 10 minutes or 3 miles (5
km) to distribute the sealant through the
tire. Drive carefully, obeying legal speed
limits, never driving faster than 50 mph (80
km/h),andavoidingsuddensteering
movements.
21. After a short drive, stop in a safe place
and re-check the tire pressure.
CAUTION
. If you notice anything unusual
while driving, pull off the road to
asafeplaceandcontacta
SUBARU dealer or Commercial
Road Service for assistance. If
the sealant has not been set
completely, the tire might lose
pressure and became unstable.
. Secure the flat tire repair kit and
bottle so that they do not move.
Otherwise, they could strike a
passenger in the event of a
sudden stop or collision and
cause injury.
NOTE
The low tire press ure warning light
might illuminate while you are driving.
22. Park your vehicle in a safe location,
and check the tire pressure using the
gauge included with the compressor to
inspect tire pressure. The proper tire
pressure can be found on the tire placard
attached to the door pillar on the driver’s
side.
23. Remove the valve cap from the sea-
lant-filled tire.
24. Connect the compressor hose (2) to
the valve on the sealant-filled tire.
In case of emergency/In case of a flat tire
9-11
– CONTINUED –
9
Loading ...
Loading ...
Loading ...