Loading ...
Loading ...
Loading ...
33
BEVEL CUT (FIG. 34)
The sliding fence must be extended when making
any bevel cut. Failure to extend the sliding fence
will not allow enough space for the blade to pass
through which could result in serious injury. At
extreme miter or bevel angles, the saw blade may
also contact the fence.
The right side sliding fence must be removed when
making right bevel angle cuts greater than 33.9° in
combination with right miter angle at 45°.
ŏ When a bevel cut is required, loosen the bevel
lock handle (1) by turning it clockwise.
ŏ Tilt the cutting head to the desired angle, as
shown on the bevel scale (2).
ŏ The blade can be positioned at any angle, from a
90° straight cut (0° on the scale) to a 45° left/right
bevel. Tighten the bevel lock handle (1) to lock
the cutting head in position. Positive stops are
provided at 33.9°, 45° and 48°.
ŏ Turn the laser guide on and position the
workpiece on the table for pre-alignment of
your cut.
COMPOUND CUT (FIG. 35)
A compound cut is the combination of a miter and a
bevel cut simultaneously.
ŏ Extend the sliding fence as described in
“SLIDING FENCE” section on page 32.
ŏ Loosen the bevel lock handle (1) and position
the cutting head at the desired bevel position.
Lock the bevel lock handle (1).
ŏ Loosen the miter handle (2) by lifting it up.
Press down the positive stop locking button (3)
and position the table at the desired miter angle.
Release the positive stop locking button (3) and
lock the miter handle (2) by pressing it down.
ŏ Turn the laser guide on and position the
workpiece on the table for pre-alignment of
your cut.
34
WARNING
!
1
WARNING
!
2
35
2
3
1
Loading ...
Loading ...
Loading ...