Kobalt SM3017LW User Manual

Loading ...

REMOVING AND INSTALLING THE TABLE

INSERTS (FIG. 5)

NOTE: The miter saw comes with the table

inserts already installed. These instructions are for

replacing or adjusting either insert side.

To avoid injury:

ŏ Always unplug the saw to avoid accidental

starting. Remove all small pieces of material

from the table cavity before performing any

cuts. The table insert may be removed for this

purpose, but always reattach the table insert

prior to performing a cutting operation.

ŏ Do not start the sliding compound miter saw

without checking for interference between the

blade and table insert. Damage could result

to the blade, table insert or turntable if a blade

strike occurs during the cutting operation.

ŏ To remove, loosen and remove the six

screws (1) on the table insert (2) with a Phillips

screwdriver and remove the inserts.

ŏ To install, reposition the left and right side

inserts on either side of the cut line, replace the

six screws and tighten.

ŏ Check for blade clearance by moving the slide

carriage through the full motion of the blade in

the table slot. If neither side of the insert hits the

saw blade, loosen the three screws for that side

and adjust. Tighten the screws and check again

for blade clearance.

Never use the saw without the table inserts in place.

ADJUSTMENT INSTRUCTIONS

WARNING

Loading ...

Kobalt SM3017LW 12-in 15-Amp Dual Bevel Sliding Compound Corded Miter Saw