Loading ...
Loading ...
Loading ...
10
ŏ FUSES may “blow” or circuit breakers may trip frequently if:
ŏ MOTOR is overloaded – overloading can occur if you feed too rapidly or make too many
starts/stops in a short time.
ŏ LINE VOLTAGE is more than 10% above or below the nameplate voltage rating. For
KHDY\ORDGVWKHYROWDJHDWPRWRUWHUPLQDOVPXVWHTXDOWKHYROWDJHVSHFL¿HGRQWKH
nameplate.
ŏ IMPROPER or dull saw blades are used.
GUIDELINES FOR EXTENSION CORDS
When using an extension cord, be sure to use one heavy enough to carry the current your
product will draw. An undersized cord will cause a drop in line voltage, resulting in loss of power
and overheating. The table below shows the correct size to use depending on cord length and
nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge number,
the heavier the cord.
MINIMUM GAUGE FOR EXTENSION CORDS (AWG)
(When using 120 volts only)
Ampere Rating Total length of Cord
More Than Not More Than 25 ft. 50 ft. 100 ft. 150 ft.
0 6 18 16 16 14
6 10 18 16 14 12
10 12 16 16 14 12
12 16 14 12 Not Recommended
Be sure your extension cord is properly wired and in good condition. Always replace a damaged
H[WHQVLRQFRUGRUKDYHLWUHSDLUHGE\DTXDOL¿HGSHUVRQEHIRUHXVLQJLW3URWHFW\RXUH[WHQVLRQ
cords from sharp objects, excessive heat and damp or wet areas.
Use a separate electrical circuit for your tools. This circuit must not be less than #12 wire and
should be protected with a 20A time-delay fuse or circuit breaker. Before connecting the tool to the
extension cord, make sure the saw switch is in the off position. The electric circuit should be rated
the same voltage as is stamped on the motor nameplate. Running at a lower voltage will damage
the motor.
In all cases make certain the receptacle in question is properly grounded. If you are not sure, have
DFHUWL¿HGHOHFWULFLDQFKHFNWKHUHFHSWDFOH
CAUTION
!
Loading ...
Loading ...
Loading ...