Loading ...
Loading ...
Loading ...
20
ŏ Repeat above steps if further adjustment is
needed.
ŏ Tighten bevel lock handle (1) when alignment is
achieved.
90° Bevel Pointers Adjustment (Fig. 16):
ŏ When the blade is exactly 90° to the table,
loosen the bevel indicator screws (1) using a
Phillips screwdriver.
ŏ Adjust bevel pointers (2) to the “0” mark on the
bevel scale and retighten the screw.
To avoid injury from an accidental start, make sure
the switch is in the OFF position and the plug is not
connected to the power source outlet.
Left/Right 45° Bevel Adjustment
(Fig. 17, 18) :
This miter saw is equipped with a bevel detent block
for positive angles stops at 33.9°, 45° and 48°.
(Fig. 18)
ŏ Turn the left bevel detent block (1) to 45°
position.
ŏ Loosen the bevel lock handle (2) by lifting up
and tilt the cutting head completely to the left.
ŏ Using a combination square, check to see if the
blade angle is 45° to the table.
ŏ If the blade is not at 45° to the miter table, tilt the
cutting arm to the right, loosen the jamb
nut (3) and turn the bevel angle adjustment
bolt (4) in or out with a 10 mm
wrench.
ŏ Tilt the cutting arm to the left 45° bevel and
recheck for alignment.
ŏ Repeat above until the blade is at 45° to the
miter table.
ŏ Tighten bevel lock handle (2) and jamb
nut (3) when alignment is achieved.
ŏ Adjust the 45° bevel on the other side following
the same steps listed above.
Left/Right 33.9° Bevel Adjustment
(Fig. 17, 18) :
ŏ Turn the left bevel detent block (1) to 33.9°
position.
ŏ Adjust the left and right side 33.9° bevel angle
using the same instructions given above for
adjusting the 45° bevel.
16
18
17
WARNING
!
1
2
33.9°
45°
48°
4
3
2
1
2
3
Loading ...
Loading ...
Loading ...