Loading ...
Loading ...
Loading ...
17
REMOVING AND INSTALLING THE BLADE
ŏUse only a saw blade diameter in accordance
with the markings on the saw.
ŏOnly use a 12 in. diameter blade with a 1 in.
arbor hole and an operating speed of more
than 4,200 RPM. Do not use blades with deep
JXOOHWV7KHVHFDQGHÀHFWDQGFRQWDFWWKH
guard, causing damage to the machine and/or
serious injury.
ŏTo avoid injury from an accidental start, make
sure the switch is in the OFF position and the
plug is not connected to the power source
outlet.
REMOVING THE BLADE (FIG. 9, 10, 11, 12, 13)
ŏ Unplug the saw from the outlet.
ŏ Raise the cutting head (1) to its upright position
as shown in Fig 9. Raise the lower blade
guard (2) to the up position shown in Fig. 9.
ŏ Loosen the cover plate screw (3) by using
the phillips head end of the provided blade
wrench (D). Only loosen it enough to position
past the tab (4).
NOTE: Do not remove this screw.
ŏ Rotate the lower blade guard (2) back to its
down position about half way. The cover plate
screw (3) should stop the guard from moving
any further and move the cover plate (5)
upward to expose the arbor bolt (6).
ŏ Place the blade wrench (D) with hex end over
the arbor bolt (6).
ŏ Locate the arbor lock button (7) on the right,
below the belt cover.
ŏ Press the arbor lock button (7), holding it in
¿UPO\ZKLOHWXUQLQJWKHEODGHZUHQFKFORFNZLVH
The arbor lock will engage after turning the
wrench, stopping the rotation of the blade.
Continue to hold the arbor lock button (7) to
keep it engaged while turning the wrench
clockwise to loosen the arbor bolt.
ŏ Remove the arbor bolt (6), the blade collar (8)
and the blade (10), as shown in Fig 13. Do not
remove the inner blade collar (9).
NOTE: The blade has an inner sleeve (11) to allow
WKHLQDUERUKROHLQWKHEODGHWR¿WWKHLQDUERU
on the motor. DO NOT THROW OUT.
NOTE: Pay attention to the pieces removed, noting
their position and direction they face. Wipe the blade
collar clean of any sawdust before installing a new
blade.
10
WARNING
!
2
6
5
9
2
1
3
3
D
4
Loading ...
Loading ...
Loading ...