Loading ...
Loading ...
Loading ...
13
To avoid injury, do not connect this miter saw to a
power source until it is completely assembled and
adjusted and you have read and understood the
operator’s manual.
UNLOCKING THE SLIDE CARRIAGE (FIG. 1)
The slide carriage lock knob (1) is located on the
right side of the slide carriage. After removing the
saw from the carton, loosen the slide carriage lock
knob (1). When transporting or storing the miter
saw, the slide carriage should always be locked in
position.
BLADE WRENCH (FIG. 2)
For convenient storage and prevention of loss, there
is a holder in the rear of the right side fence for
storing the blade wrench (D) when not in use.
Place the provided wrench in this location.
INSTALLING THE DUST BAG (FIG. 3)
ŏ Install the dust bag (C) onto the exhaust port (1)
on the miter saw. Fit the connecting tube of dust
bag and the exhaust port together. The dust bag
assembly should be angled toward the side of
the saw (as shown in Fig 3) for best results. This
will also avoid any interference during the saw
operation.
NOTE: To empty the dust bag, pull out the dust bag
from exhaust port. Open zipper on underside of bag
and empty into waste container.
IMPORTANT: Check frequently and empty bag
before it gets full.
Do not use this saw to cut and/or sand metals. The
hot chips or sparks may ignite sawdust from the bag
material.
ASSEMBLY INSTRUCTIONS
1
2
3
WARNING
!
WARNING
!
1
1
C
D
Loading ...
Loading ...
Loading ...