Loading ...
Loading ...
Loading ...
23
SETTING CUTTING DEPTH (FIG. 22)
The depth of cut can be preset for even and
repetitive shallow cuts.
ŏ Adjust the cutting head down until the teeth of
the blade are at the desired depth.
ŏ While holding the upper arm in that position,
turn the stop knob (1) until it touches the stop
plate (2).
ŏ Recheck the blade depth by moving the cutting
head front to back through the full motion of a
typical cut along the control arm.
NOTE: Use a wooden spacer between the
fence and the workpiece for a consistent
depth through the cut. Use the hold-down
clamp to secure the wooden spacer and
ZRUNSLHFH¿UPO\EHIRUHPDNLQJWKHFXW
MAXIMUM CUTTING DEPTH (FIG. 22)
The maximum depth travel of the cutting head was
set at the factory.
Ɣ 5RWDWHWKHVWRSSODWHFORFNZLVHWRWRXFKWKH
stop rod (3).
Ɣ 5HFKHFNWKHEODGHGHSWKE\PRYLQJWKHFXWWLQJ
head front to back through the full motion of a
typical cut along the control arm.
TO TURN LASER GUIDE ON (FIG. 23)
ŏ To turn laser on, press on/off rocker
switch (1) to “ON” position.
ŏ To turn laser off, press on/off rocker
switch (1) to “OFF” position.
ALIGNING THE LASER GUIDE (FIG. 23, 24)
The laser beam must always be correctly aligned
with the blade to ensure straight, even cutting. Your
tool is equipped with a laser cutting guide that uses
a Class II laser beam. The laser beam will enable
you to preview the saw blade path on the stock to
be cut before starting the miter saw. The saw must
be connected to the power source and the laser
on/off switch must be turned on for the laser
line to show.
When doing any laser guide adjustments, always
insert a padlock or chain with padlock (not included)
through the hole (2) in the trigger switch, locking the
tool’s switch and preventing turning the machine on.
Do not remove the padlock from the ON/OFF switch
until all laser adjustments are completed.
22
1
2
23
1
2
WARNING
!
Loading ...
Loading ...
Loading ...