1
2
3
4
5
2 Programs2 Programs
6
3
Sec.
Wahl
®
Heated Lumbar Massage Cushion Quickstart Guide
part no:
58413
Additional information available at massagers.wahl.com or 1-800-767-9245.
Insert adaptor jack into the plug on the right
side of the unit.
Plug wall adaptor into AC 120-volt outlet or car
adaptor into cigarette lighter power supply.
To turn the unit on, press the power button on
the controller once.
To change the programs, press the power
button. Select from multiple settings by
pressing the programs button successively
until desired program is found.
To turn the heat on, press the heat button
once. Press again to turn heat off. The heat will
not turn on until the power button has been
pressed.
To turn the unit off, hold the power button for
3 seconds. This unit automatically turns off
after 20 minutes.
Adaptor
Cord
Plug for
Adaptor
Jack
Prepare for use at
home, in the office,
or in the car:
Place the unit in a
chair or car seat, and
pull the attached
elastic strap over top
of the chair or seat to
hold the cushion in
place. Make sure the
unit is flush with the
chair or seat to allow
for maximum benefit
of the lumbar support.
Programs
LOW Vibration — for
soothing massage
HIGH Vibration — for
vigorous, deeper
massage
OFF — if you prefer
heat only
Wahl
®
Heated Lumbar Massage Cushion Key Features
Power
On/Off &
Programs
Button
Adaptor
Jack
Wall Adaptor
(Operates on
120V, 60HZ Only)
Car Adaptor
Adaptor
Jack
Heat Coils
throughout entire
Lumbar Support
4 Massage Nodes
in the Lumbar
Support
Heat
Button
If you are not satisfied with your Wahl Heated Lumbar Massage Cushion, please feel free to contact us at massagers.wahl.com or 1-800-767-9245.
