Loading ...
Loading ...
Loading ...
9
FIGURE 1A
(2) SCREWS
IGNITOR
BURNER
TUBE
PRESSURE
TAP PLUG
GAS VALVE
ASSEMBLY
Determining Gas Valve Style
CHANGING THE ORIFICE (BOTH STYLES)
1. Remove the two (2) screws securing the burner tube to
the burner base. See Figures 1A and 1B.
FIGURE 2
IGNITOR
BURNER
TUBE
GAS VALVE
ASSEMBLY
2. Slide burner tube forward far enough to gain access to
orice. Do not bump ignitor. See Figure 2.
NOTE: The ignitor is fragile.
FIGURE 1B
(2) SCREWS
IGNITOR
BURNER
TUBE
PRESSURE
TAP PLUG
GAS VALVE
ASSEMBLY
SECTION 4 –7 TO 7.5 CUBIC FOOT MODELS WITH 27"
CABINET, TOE PANEL, AND REAR CONSOLE
Disassemble to access gas valve. To remove the toe panel
on some models, a small at-head screwdriver is required
to release the clips at top of panel. Continue to “Determining
Gas Valve Style” – “Changing the Orice.”
5. Reach around the back of the drive motor and push the
idler wheel arm to relieve the spring tension on the belt;
then slide the belt off the idler and motor pulleys.
See Figure 4.
FIGURE 4
FIGURE 5
6. Loosen the top two (2) hex-head screws and remove the
bottom two (2) hex-head screws from the front bulkhead.
Remove the lower two (2) screws from the blower air duct.
Gently remove the bulkhead and blower air duct from the
front of the dryer. See Figure 5.
7. Remove the drum from the dryer cabinet.
8. Disconnect ignitor wires from harness then remove
the burner tube by removing the two (2) screws securing
it to the burner base. See Figure 1B; then continue to
“Determining Gas Valve Style” – “Changing the Orice.”
BLOWER
AIR DUCT
BELT
TOP TWO (2)
SCREWS
BOTTOM TWO (2)
SCREWS
LOWER TWO (2)
SCREWS
BULKHEAD
Loading ...
Loading ...
Loading ...