Loading ...
Loading ...
Loading ...
5
5. Remove front panel assembly by opening door and
remove the two (2) screws as shown in Figure 5. After
removal of these screws, close door.
6. Disconnect door switch connector. See Figure 6.
4. Disconnect drum light connector and main console
connector as shown in Figure 4. Lift up on console
and tilt assembly forward to remove console.
NOTE: Only on models with the CCU Bracket located on
the left side of the unit.
FIGURE 6
DOOR
SWITCH
CONNECTOR
7. Remove front panel by rst removing four (4) screws from
bottom of front panel as shown in Figure 7.
FIGURE 5
(2) SCREWS
FRONT
PANEL
DRYER DOOR
FIGURE 4
MAIN CONSOLE
CONNECTOR
FIGURE 7
(4) SCREWS
FRONT PANEL
DRUM LIGHT
CONNECTOR
CCU
BRACKET
FIGURE 9
TAB
FRONT
PANEL
FIGURE 8
(3) SCREWS
8. Next remove the three (3) screws from the top of the front
panel as shown in Figure 8.
9. Remove front panel assembly from dryer by lifting panel
assembly up and off tabs (one each side) as shown in
Figure 9.
10. Next remove console mounting bracket by removing two (2)
screws securing bracket to cabinet left side panels, two (2)
screws from right side panel and one (1) screw from central
control bracket. Slightly lift assembly and remove from dryer.
See Figures 10A and 10B.
FIGURE 10A
(2) SCREWS -
LEFT SIDE
Loading ...
Loading ...
Loading ...