Loading ...
2
Disassembling the Dryer
SECTION 1 – 8.8+ CUBIC FOOT MODELS WITH 29" CABINET,
FULL FRONT PANEL, AND REAR CONSOLE
To gain access to inside of dryer:
1. Remove console rear plate and rear shelf plate by
removing a total of eight (8) screws. See Figure 1.
2. Remove two (2) screws from the rear of the top.
See Figure 2. This will allow the top to be slid rearward.
3. Disconnect the door switch connector located in the top
left front corner of the dryer. See Figure 3.
4. Remove the front panel and door assembly by removing
a total of eleven (11) screws: Four (4) ¼" hex-head screws
along the bottom front, three (3) Phillips-head screws around
the door opening, and four (4) T-20 Torx-head screws on
the top front panel bracket. See Figure 4. Once screws are
removed, close the door and lift up the front panel and door
assembly to remove.
(3) SCREWS
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
5. Disconnect the drum light connector located in the top left
front corner of the dryer. See Figure 5.
FIGURE 5
(5) SCREWS
CONSOLE
REAR
PLATE
REAR
SHELF
PLATE
(2) SCREWS
DOOR SWITCH
CONNECTOR
(3) SCREWS
(4) SCREWS
FRONT
PANEL
DRUM LIGHT
CONNECTOR
TOP
(4) SCREWS
Loading ...
Loading ...
Loading ...