Loading ...
Loading ...
Loading ...
Problem solving guide
54
Problem Cause and remedy
After the hob has been
switched on or a sensor
has been touched
appears in the timer
display for a few
seconds.
The system lock or safety lock is activated.
Deactivate the system lock or safety lock (see
"System lock / Safety lock").
The hob has switched
off automatically. When
the hob is switched
back on, an appears
above the On/Off
sensor.
One or more of the sensors are covered, e.g. by finger
contact, food boiling over or an object.
Clean off any dirt or remove the object (see
"Safety switch-off").
After the hob has been
switched on, flashes
alternately with in
the timer display. The
cooking zones do not
heat up.
The hob is in demonstration mode.
Deactivate demonstration mode (see "Program-
ming").
A cooking zone
switches off automatic-
ally.
It has been operated for too long.
You can use the cooking zone again by switching
it back on (see "Safety switch-off").
A cooking zone or the
whole hob switches off
automatically.
The overheating protection mechanism has been ac-
tivated.
See "Overheating protection".
The Booster has deac-
tivated early automatic-
ally.
The overheating protection mechanism has been ac-
tivated.
See "Overheating protection".
The cooking zone is not
working in the usual
way on the power set-
ting selected.
The overheating protection mechanism has been ac-
tivated.
See "Overheating protection".
Power level 9 is auto-
matically reduced if you
select power level 9 on
two linked cooking
zones at the same time.
Operating both zones at power level 9 would exceed
the permitted maximum power for the two zones.
Use a different cooking zone.
Loading ...
Loading ...
Loading ...