Loading ...
Loading ...
Loading ...
HomeConnect en
49
4. Once your appliance is displayed
in the HomeConnect app, carry
out the last steps in the
HomeConnect app.
a If the display shows Connected,
the appliance is connected to the
HomeConnect app.
Connecting the appliance to
the energy manager
If you connect the appliance to the
smart energy system (energy man-
ager), you will optimise your energy
consumption. The appliance starts
only when your home photovoltaic
system can provide sufficient energy
or the energy tariff is good.
Requirements
¡ The smart energy system (energy
manager) must use the EEBus Initi-
ative communications standard.
¡ You have read about how to con-
nect your appliance to the smart
energy system (energy manager)
in the instruction manual for the
smart energy system (energy man-
ager).
1. Press and hold RemoteStart
for approx. 3 seconds.
2. Select energy mngmt..
3. Select Connect.
4. Confirm the message in the dis-
play.
a The appliance is connected to the
smart energy system (energy man-
ager)
a If the appliance has connected to
the energy manager successfully,
the display shows .
5. Activate Flex Start if you want the
smart energy system (energy man-
ager) to start up your appliance.
→"Activate Flex Start", Page49
Activate Flex Start
Activate Flex Start to allow your smart
energy system (energy manager) to
start your appliance once your home
photovoltaic system is able to
provide sufficient energy or the en-
ergy tariff is good.
Requirement:The smart energy sys-
tem (energy manager) cannot start
your appliance until it is connected to
the appliance.
1. Set the programme you require.
2. Press Finish in to set the required
time.
3. Press Start/Reload .
a The display shows Delayed start.
4. Press RemoteStart .
a If the display shows Flex Start,
Flex Start is activated and the ap-
pliance waits to be started by the
smart energy system (energy man-
ager).
a If the display changes to : Ready
in approx., the smart energy sys-
tem (energy manager) has estab-
lished a time at which your appli-
ance can start.
a If the smart energy system (energy
manager) does not start the appli-
ance within the set time, the appli-
ance will start the programme itself
before the set time period ends.
The programme ends when the
time period ends.
Note
Flex Start is deactivated for safety
reasons in the following circumstances:
¡ Press Start/Reload .
¡ Open the door.
¡ Switch off the appliance.
¡ Power failure.
Loading ...
Loading ...
Loading ...