Loading ...
Loading ...
Loading ...
Winding/Installing the Bobbin
GETTING READY
19
1
Installing the bobbin
Install the bobbin wound with thread.
You can begin embroidering immediately without pulling up
the bobbin thread by simply inserting the bobbin in the
bobbin case and guiding the thread through the slit in the
needle plate cover.
a
Turn on the machine.
b
Press (Needle position button) once or twice to
raise the needle.
c
Press .
• When the message [OK to automatically lower the
presser foot?] appears on the LCD screen, press
to continue.
The screen changes, and all keys and operation
buttons are locked (except ).
d
Raise the presser foot lever.
e
Slide the bobbin cover latch to the right and remove
the bobbin cover.
f
Insert the bobbin into the bobbin case so that the
thread unwinds to the left.
g
Lightly hold down the bobbin with your right hand
(1), and then guide the end of the thread around the
tab of the needle plate cover with your left hand (2).
CAUTION
• Use a bobbin that has been correctly wound
with thread, otherwise the needle may break
or the thread tension will be incorrect.
• Before inserting or changing the bobbin, be
sure that you have pressed on the
operation panel to lock all keys and buttons,
otherwise injuries may occur if the “Start/
Stop” button or any other button is pressed
and the machine starts.
Memo
• For the correct winding direction of the bobbin
thread, be sure to place the bobbin into the bobbin
case in the same orientation that it was on the
bobbin winder shaft.
The “b” mark on one side of the bobbin included
with this machine can be used as a reference.
1 Tab
CAUTION
• Be sure to hold down the bobbin with your
finger and unwind the bobbin thread
correctly, otherwise the thread may break or
the thread tension will be incorrect.
Loading ...
Loading ...
Loading ...