Loading ...
Loading ...
Loading ...
17
Communication Ports
Dry Contacts
RS485/CAN
USB
To use this to function, an auto start controller must be installed on the generator.
there are three contacts; up to down: NO, N, NC
NOTE
When using both USB and RS485, you can only use one of two alternatives, not use
both simultaneously .
NOTE
the NO-N contact can drive the resistive load of 125VAC/1A,
30DCV/1A
This port will be used for connecting to the BT-2 Accessory for
remote monitoring and control.
While the generator is connected, the unit now operates in
“Charging Mode” with the AC power from the Generator charging
the batteries as well as providing power to the AC loads.
The USB port is for internal purposes only. It will not be supported
as it requires proprietary information.
NOTE
NOTE
Do not store units with auto gen start feature enabled. Generators exhaust
dangerous fumes when running.
This contact automatically starts the generator and charges the battery bank.
Under normal conditions, this terminal is NC-N point closed, NO-N point
open. When the battery voltage reaches the low voltage point, the relay coil
is energized, and NO-N point now is closed and NC-N point now is open.
WARNING
1
2
3
4
5
6
7
8
5V
RS485-A
RS485-B
GND
NC
CAN_H
NC
CAN_L
Pin No. Parameter
NO
NC
N
Loading ...
Loading ...
Loading ...