Loading ...
Loading ...
Loading ...
27
TROUBLESHOOTING
Code Description How to Troubleshoot
----- Safety key fault.
1. Insert the safety key properly.
2.
Replace the safety key sensor or safety key. If
there’s still a problem, replace the top console.
E01
Communication abnormality: no
communication from the top
console to the control board.
Possible Reasons: Communication obstructed
between control board and top console, please check
to make sure the wires are connected properly, and
the wires are without any punctures or damage.
If this does not resolve the issue, check the control
board and PCB IC to see if there’s any damage,
replace if necessary.
E02
Motor fault or control board
fault.
1. Check if the motor cable is well connected.
Reconnect the wire and restart.
2.
Check the motor or the control board for any
damage. Replace if necessary.
E04
Incline failure: the incline motor
sensor wire is damaged or the
wire for the incline motor is not
properly connected.
Check incline motor sensor wire and AC wire to see if
they are properly connected.
Make sure the incline
motor wire does not have any punctures or damage.
E05
Current overload protection.
Possible R
easons: Excessive current load, the
incoming voltage is too low or too high. The control
board is damaged.
A moving part of the treadmill is
stuck, and the motor is unable to function properly.
Try to restart the treadmill. Also, check if there’s any
burnt odors around the motor and control board. Make
sure the power and voltage comply with the standard.
Inspect moving parts to ensure they
are operating
correctly. Listen for unfamiliar noises from the motors.
E06 Burst clash protection.
Possible Reasons: T
he power voltage is less than
normal by 50% or the controller has problems. Make
sure the motor wires are connected. Check the control
board for any damage or burnt odors. R
eplace if
necessary.
No display in
console
Control board abnormality.
1. Check if the overload button switch is off, if so,
press to turn it on.
2.
Check the wire on the power switch, overload
button, and control board to see if it is connected
properly.
3. Check the top console wires and all cables between
the top console and control board.
4. Check the transformer and replace if necessary.
Version 3.3
Loading ...
Loading ...
Loading ...