Loading ...
Loading ...
Loading ...
En 137
• Even if “Auto/Manual Select” is set to “Auto”, the automatic adjustment does not work depending on
the TV connected to the unit. In this case, adjust the delay manually in “Adjustment”.
Adjusts the delay between video and audio output manually when “Auto/Manual
Select” is set to “Manual”. You can fine-adjust the audio output timing when
“Auto/Manual Select” is set to “Auto”.
Setting range
0
ms to 500 ms (1 ms increments)
• When “Auto/Manual Select” is set to “Auto”, “Offset” shows the difference between automatic
adjustment and fine adjustment.
■ Dynamic Range
Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and
DTS signals) playback.
Settings
■ Max Volume
Sets the maximum volume to prevent excessive loudness.
Setting range
-30.0 dB to +15.0 dB (5.0 dB increments), +16.5
dB
■ Initial Volume
Sets the initial volume when the receiver is turned on.
Settings
■ Pure Direct Mode
Selects whether to output video signals during the Pure Direct mode (p.80).
Settings
■ Adaptive DSP Level
Selects whether to automatically adjust the CINEMA DSP effect level.
Settings
Adjustment
Maximum Produces audio without adjusting the dynamic range.
Standard Optimizes the dynamic range for regular home use.
Minimum/Auto
Sets the dynamic range for clear sound even at night or at low
volumes.
When playing back Dolby TrueHD signals, the dynamic range is
automatically adjusted based on the input signal information.
Off
Sets the level to the volume level of the unit when it last entered
standby mode.
On
Sets at Mute or the specified volume level (-80.0 dB to +16.5 dB,
0.5 dB increments).
(Specify a volume level which is lower than the “Max Volume” setting.)
Auto
Automatically outputs video signals when any videos are input from the
selected input source or an input source that can be operated with the
on-screen display is selected. When no video signals are input, the
wall paper is displayed.
Video Off Does not output video signals including the wall paper.
Off Does not adjust the effect level automatically.
On
Adjusts the effect level automatically according to the YPAO
measurement results and the volume level.
Loading ...
Loading ...
Loading ...