Loading ...
Loading ...
Loading ...
Manage and Monitor the Switch
38
NETGEAR ProSAFE Plus Configuration Utility
Note: To navigate to this page, select System > Status > Switch Status.
6. For each port that you want to configure, in the Speed menu, select one of the following
options:
• Auto. The port speed is set automatically after the switch determines the speed using
auto-negotiation with the link partner. This is the default setting.
• Disable. The port is shut down.
• A specific speed and duplex mode, which depends on the switch model. If you select
a specific speed and duplex mode, the port is forced to function at that speed and
duplex mode. Ports that function at 1000M always function in full duplex mode.
7. Click the APPLY button.
Your settings are saved.
Enable Loop Detection
If loop detection is enabled and the switch detects a loop, both LEDs of a port blink at a
constant speed.
To enable loop detection:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that is
off-network using an Ethernet cable.
2. Launch the ProSAFE Plus Utility using the desktop icon or tile.
The Switch Selection page displays a list of Web Managed (Plus) switches that it
discovers on the local network.
3. Select the switch.
If you do not see the switch, click the REFRESH button.
4. Click the APPLY button.
You are asked to enter the password for the switch.
5. Enter the switch’s password in the password field.
The switch’s default password is password.
The Switch Status page displays.
6. Select System > Management > Loop Detection.
The Loop Detection page displays.
7. Select the Enable radio button.
8. Click the APPLY button.
Your settings are saved.
Loading ...
Loading ...
Loading ...