Loading ...
Loading ...
Loading ...
Manage Network Settings
14
NETGEAR ProSAFE Plus Configuration Utility
3. Select the switch.
If you do not see the switch, click the REFRESH button.
4. Click the APPLY button.
You are asked to enter the password for the switch.
5. Enter the switch’s password in the password field.
The switch’s default password is password.
The Switch Status page displays.
6. Select System > Multicast.
The previous figure is an example. Your switch might support more or less VLANs for
IGMP snooping.
7. Make sure that the IGMP Snooping Status Enable radio button is selected.
8. In the VLAN ID Enabled for IGMP Snooping field, enter the ID of the VLAN.
By default, if you enable IGMP snooping, snooping occurs on VLAN 1. However, you can
enable snooping on any VLAN:
• For port-based VLANs, you can enter a VLAN ID from 1 to the maximum number that
you switch supports (5, 8, 16, or 24).
• For 802.1Q-based VLANs, you can enter a VLAN ID from 1 to 4094.
9. Click the APPLY button.
Your settings are saved.
Set Up Static Link Aggregation Groups
Link aggregation groups (LAGs) allow you to combine multiple Ethernet links into a single
logical link. Network devices treat the aggregation as if it were a single link, which increases
fault tolerance and load sharing. The number of LAGs that the switch supports depends on
the model. Configure LAG membership before you enable the LAG.
Note: Static link aggregation (port trunking) is supported on the following
models:
Loading ...
Loading ...
Loading ...